Welcome to the forum for REALCOM users. Feel free to post your question about REALCOM here. The Centre for Multilevel Modelling take no responsibility for the accuracy of these posts, we are unable to monitor them closely. Do go ahead and post your question and thank you in advance if you find the time to post any answers!
I've just run my realcom model but having successfully loaded it into Stata, one variable (logbmi) was not imputed (i.e. when I type 'mi xeq: summarise varx', no imputed values are included).
Not sure where to start - it was definitely listed in my realcom model as a response when I just checked again.
Any ideas about how to troubleshoot this would be welcome.
I would suggest looking at the impvals.txt file that was saved from Realcom-Impute. If the missing variable isn't referenced there then it's probably a Realcom problem, otherwise it's likely to be something wrong with the -realcomImputeLoad- command.
I re-ran the Realcom model and for some reason I couldn't replicate the error. Which is good in the end I suppose, but a bit confusing as I didn't change any of the settings.